Contax I4R User Manual download pdf (Page 28)

Introduction Getting Ready

Taking Pictures

Playback Set Up

EN-28

NEXTBACK

Contents Glossary Index Nomenclature Menus and Settings Troubleshooting

Inserting the Memory Card

Check that the camera is switched off

and then release the card/battery cover

latch.

qUse the pad of your finger to slide the card/battery cover in the

direction of the arrow until there is a click and the latch is released

(approximately 1 mm).

wThe bottom part of the card/battery cover opens (approximately

10 mm).

2 Open the card/battery cover.

ePull out the card/battery cover until it is stopped by the hinge.

rFully open the card/battery cover.

3 Insert the memory card.

Insert the memory card with the labeled side facing the lens side of the

camera.

When inserting the card, push it into the slot until it makes a clicking

sound and stops.

4 Close the card/battery cover.

Push the card/battery cover into the opening in the camera surface

while you close it, then slide it in the direction of the arrow until it clicks

and locks.

Make sure the hinge does not lift up as you close the cover.

A Important

• If the card does not slide in smoothly, the card may be upside down. Check that the

card is the right way up and do not try to force it into the slot.

• Do not attach stickers of any sort to the memory card as this may jam the card in

the slot so that you cannot remove it.

BNote

Format the memory card in the camera before shooting to ensure the best possible

performance from the camera. (Æ p.161

)

Hinge

Memory

Card Slot

Labeled

Surface

Cutout

Section

Push against

the upper

surface.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 196 197

Comments to this Manuals

No comments

Contax I4R User Manual Page 28

Comments to this Manuals